0. Final Assembly - Team Losi LOS-A0951 Owner's Manual

FINAL ASSEMBLY
NOTE: Since there are very few parts required to complete the final assembly portion of the manual, the
· parts have been packaged in the Radio Installation bag.
Fig 99.
Step 1. Trim the body (182) along the trim lines as shown. Cut out the areas indicated on the front and side windows to
allow easy access to the fuel tank.
Step 2. Make three 5/16" diameter holes in the areas on the windshield and hood of the body (182) that are marked with
dimples or small circles.
Step 3. Drill a 3/8" diameter hole in the rear of the body at the location marked with a small hole or dimple.
Step 4. Place one half of the body saver (183) on the top side of the body over the 3/8" hole. Insert the other half of the body
saver (183) into the hole in the rear of the body, from the bottom side. Snap the two halves of the body saver (183) together.
Step 5. Attach the body (182) to the truck and secure it by placing a body clip (184) through each of the two holes in the
front body mount (12), and the top hole in the rear shock tower (96).
BODY AND WHEEL DISC PAINTING
Prepare the body shell for painting by washing it thoroughly with warm water and a small amount of liquid detergent. Dry
the body with a clean, soft cloth. Use the window masks (185), supplied with the kit, to cover the window areas from the inside.
A high grade masking tape should be used on the inside of the body to mask off any stripes, panels, or designs that you wish to
paint on the body or wheel discs. Use acrylic lacquer, acrylic enamel, or any other Lexan (Polycarbonate) recommended paints.
Apply paint to the inside of the body. Remove the tape for the area that you wish to apply the next color to and continue with the
next color. Try to use the darker colors first. If you use a dark color after a light color, apply a thin coat of white over the lighter
color before continuing with the darker color.
STICKERS
Cut the stickers from the sticker sheet (186) that you wish to use. Before removing the protective backing, find the desired
location for the sticker. Remove the backing completely and reattach an edge of the sticker to the shiny side of the backing
paper. Using the rest of the backing as a handle, position the sticker over the desired location and press it firmly into place to
complete its application.
/
'
Figure 99
45