Bag C; Steering Bellcrank Assembly - Team Losi XXX-S Graphite Owner's Manual

Step C-1

Steering Bellcrank Assembly

43
13
q
1. Thread a 3/16" Ballstud (43), from the top side, into each of the
Left (42) and Right (41) Bellcranks.
q
2. Insert a 5mm x 8mm Bearing (13) into the top and bottom of the
Left and Right Bellcranks.
q
3.Thread a 3/16" Ball Stud (43) into the small hole from the top
side of the Draglink (48).
q
4. Insert the 2 Carrier / Steering bushings (47), into the bottom
side of the Draglink (48) and then rest it on the top of the Left and
Right Bellcranks.
q
5. Thread a 4-40 x 3/8" Button Head Screw (49) through the Car-
rier / Steering Bushing and into each Bellcrank.
Step C-2
Steering Bellcrank Install
q
1. Line up the Hex on the Steering Post (44) with the rear Hex area
on left side of the Chassis (27). Press the Steering Post to the bottom
of the Hex. Thread a 4-40 x 3/8" Flat Head Screw (31) through the
bottom of the Chassis and into the Steering Post.
q
2. Repeat step 1 for the right side steering post.
q
3. Slide the Steering Assembly from step C-1 through the Steer-
ing Tunnel (28) with the large holes facing forward, and then slide the
Left Bellcrank (41) over the Steering Post on the left side of the Chas-
sis.
q
4. Sliding the Right Bellcrank (42) over the Right Steering Post
will need to be done at the same time as the Left Bellcrank.
The bellcrank should rotate freely.

BAG C

49
47
31
43
42
LARGE HOLES
FORWARD
42
41
27
8
43
13
41
Figure 18
Figure 19A
48
28
44
31
LARGE HOLES
Figure 19B
49
48
47