Mounting The Realpresence Collaboration Server (Rmx) 4000 In A Rack - Polycom 1500 Getting Started Manual

RealPresence Collaboration Server (RMX) 1500/1800/2000/4000 Getting Started Guide
.
2 Push the card into the slot until the ejector levers touch the front edge of the card cage. Push the
ejector levers to their fully closed position.
3 Tighten the captive screws on each side of the rear panel of the card, securing the RTM ISDN card
to the MCU.
A Software License is included with the ISDN card. This license must be registered as part of the Product
Registration and Product Activation process.

Mounting the RealPresence Collaboration Server (RMX) 4000 in a Rack

Either place the RealPresence Collaboration Server (RMX) 4000 on a hard, flat surface such as a desktop
or mount it on a 19" rack
.T install the RealPresence Collaboration Server (RMX) 4000 in a 19"rack:
For a detailed description of the safety requirements and precautions and the installation of the
RealPresence Collaboration Server (RMX) 4000 as a standalone, or reverse mounting the
RealPresence Collaboration Server (RMX) 4000 on a 19" rack, see the RealPresence Collaboration
Server (RMX) 4000 Hardware Guide.
● Using rack rail runners on the RealPresence Collaboration Server (RMX) 4000
 Install the telescopic rail runners, as described in
Rack .
 Mount the RealPresence Collaboration Server (RMX) 4000 on top of the rail runners.
 Fasten the Collaboration Server to the rack spacers using the flat head screw
flat washer
brackets.
Polycom®, Inc.
(item 9) through the two holes in the Collaboration Server's front mounting
Installing the Telescopic Rail Runners on the
(item 8) with
47