Polycom 1500 Getting Started Manual page 68

RealPresence Collaboration Server (RMX) 1500/1800/2000/4000 Getting Started Guide
2 Power the Collaboration Server ON.
 AC System - Turn ON the power by pressing on the power switch located on the rear panel of the
RealPresence Collaboration Server (RMX) 1500/2000/4000.
 On the RealPresence Collaboration Server (RMX) 1500, the ON/OFF button is lit (ON).
 On the RealPresence Collaboration Server (RMX) 2000/4000, the FAN STATUS and PWR
STATUS LEDs turn ON.
 DC System (RealPresence Collaboration Server (RMX) 4000) - Turn ON the Main that supplies
power to the Collaboration Server and then turn ON each of the DC power rail modules.
3 Press the power button on the system. The power indicators should light.
System power-up sequence may take approximately 105 minutes.
During this time, the parameters in the lan.cfg file are uploaded from the USB memory stick to the
MCU's memory and applied during the power-up sequence.
Wait for the upload process to complete. Initially, all the READY/IN USE/ERROR LEDs on the
RealPresence Collaboration Server (RMX) 1500 or ERR/RDY/ACT LEDs on the RealPresence
Collaboration Server (RMX) 2000/4000 flicker and flash. Upload is completed when all the LEDs turn
off and only the red ERROR/ERR LED (on the CTNL unit of the RealPresence Collaboration Server
Polycom®, Inc. 59