Follow these steps to configure a multicast group filter:
To do...
Enter system view
Enter interface view
Configure a multicast group
filter
Configuring the Maximum Number of Multicast Groups on an Interface
You can configure the allowed maximum number of multicast groups on an interface to flexibly control
the number of multicast groups the interface can join.
Follow these steps to configure the maximum number of multicast groups an interface can join:
To do...
Enter system view
Enter interface view
Configure the maximum number of
multicast groups that can be joined
on the current interface
This configuration takes effect for dynamically joined multicast groups but not the statically configured
multicast groups.
Adjusting IGMP Performance
For the configuration tasks described in this section:
Configurations performed in IGMP view are effective on all interfaces, while configurations
performed in interface view are effective on the current interface only.
If the same feature is configured in both IGMP view and interface view, the configuration performed
in interface view is given priority, regardless of the configuration sequence.
Use the command...
system-view
interface interface-type
interface-number
igmp group-policy
acl-number [ version-number ]
Use the command...
system-view
interface interface-type
interface-number
igmp group-limit limit
1-11
Remarks
—
—
Required
By default, no multicast group
filter is configured on this
interface, namely hosts on the
current interface can join any
valid multicast group.
Remarks
—
—
Required
1024 by default