Mce Configuration Example - HP 4800G Series Configuration Manual

Table of Contents

MCE Configuration Example

MCE Configuration Example (A)

Network requirements

An MCE device connects to VPN1 (with the address range being 192.168.0.0/16) through

VLAN-interface 10 (with the IP address being 10.214.10.3) and connects to VPN2 (with the

address range being 192.168.10.0/24) through VLAN-interface 20 (with the IP address being

10.214.20.3). VPN2 has RIP enabled.

The MCE device connects to the PE through VLAN-interface 30 and VLAN-interface 40, whose IP

addresses are 192.168.30.1/30 and 192.168.40.1/30, respectively.

It is required that the MCE device isolates routes of VPN1 from those of VPN2 and advertises all

the VPN routes to the PE device using OSPF.

Network diagram

Figure 2-1 Network diagram for MCE configuration (A)

Configuration procedure

For distinguish devices, assume the system name of the MCE device is "MCE", the names of the egress

router of VPN1 and VPN2 are "VR1" and "VR2", and the system name of the PE device is "PE".

Configure VPN instances

# Configure two instances VPN1 and VPN2 on the MCE device, with the RD values of the two VPN

instances being 10:1 and 20:1.

<MCE> system-view

[MCE] ip vpn-instance vpn1

[MCE-vpn-instance-vpn1] route-distinguisher 10:1

[MCE-vpn-instance-vpn1] quit

192.168.10.0

Table of Contents