Test Types Supported By Hwping; Hwping Test Parameters - H3C S5600 Series Operation Manual

Figure 1-1 HWPing illustration

Test Types Supported by HWPing

Among the test types supported by HWPing, only the ICMP test can be performed when IRF fabric is
enabled; all other test types cannot be performed when IRF fabric is enabled.
Table 1-1 Test types supported by HWPing
Supported test types
ICMP test
DHCP test
FTP test
HTTP test
DNS test
SNMP test
Jitter test
TCP test
UDP test

HWPing Test Parameters

You need to configure corresponding test parameters for each type of HWPing test. HWPing test
parameters can be configured on HWPing client only. For the configurations on the HWPing client, refer
to section HWPing Client
Table 1-2 HWPing test parameters
Test parameter
Destination address
(destination-ip)
Destination port
(destination-port)
For these types of tests, you need to configure the HWPing client and
corresponding servers.
Tcppublic test
Tcpprivate test
Udppublic test
Udpprivate test
Configuration.
For a TCP/UDP/jitter test, you must specify a destination IP address, and the
destination address must be the IP address of a TCP/UDP/UDP listening service
configured on the HWPing server.
For a tcpprivate/udpprivate/jitter test, you must specify a destination port
number, and the destination port number must be the port number of a TCP or
UDP listening service configured on the HWPing server.
These types of tests need the cooperation of the HWPing client and
HWPing server.
Do not perform a TCP, UDP or jitter test on a well-known port (ports
with a number ranging from 1 to 1023). Otherwise, your HWPing
test may fail or the service corresponding to the well-known port
may become unavailable.
Description
1-2
Description