Yamaha WR250F(P) Owner's Service Manual page 586

SWINGARM
5. Install:
Relay arm 1
G
Bolt (relay arm) 2
G
Washer 3
G
Nut (relay arm) 4
G
To swingarm.
NOTE:
Apply the molybdenum disulfide grease on
G
the bolt.
Do not tighten the nut yet.
G
6. Install:
Swingarm 1
G
Pivot shaft 2
G
NOTE:
Apply the molybdenum disulfide grease on
G
the pivot shaft.
Insert the pivot shaft from right side.
G
7. Check:
Swingarm side play a
G
Free play exists → Replace thrust bear-
ing.
Swingarm up and down movement b
G
Unsmooth movement/binding/rough
spots → Grease or replace bearings,
bushings and collars.
8. Install:
Bolt (connecting rod) 1
G
Washer 2
G
Nut (connecting rod) 3
G
NOTE:
Apply the molybdenum disulfide grease on
G
the bolt.
Do not tighten the nut yet.
G
9. Install:
Bolt (rear shock absorber-relay arm) 1
G
Nut (rear shock absorber-relay arm) 2
G
NOTE:
Apply the molybdenum disulfide grease on the
bolt.
5 - 58
CHAS
85 Nm (8.5 m · kg, 61 ft · lb)
53 Nm (5.3 m · kg, 38 ft · lb)