Engine Idling Speed Adjustment; Valve Clearance Inspection And Adjustment - Yamaha WR250F(P) Owner's Service Manual

VALVE CLEARANCE INSPECTION AND ADJUSTMENT

ENGINE IDLING SPEED ADJUSTMENT/

ENGINE IDLING SPEED ADJUSTMENT
1. Start the engine and thoroughly warm it
up.
2. Attach:
Inductive tachometer
G
To spark plug lead.
3. Adjust:
Engine idling speed
G
Adjustment steps:
Adjust the pilot screw.
G
Refer to "PILOT SCREW ADJUSTMENT"
section.
Turn the throttle stop screw 1 until the
G
engine runs at the lowest possible speed.
To increase idle speed → Turn the throt-
tle stop screw 1 in a.
To decrease idle speed → Turn the throt-
tle stop screw 1 out b.
Inductive tachometer:
YU-8036-B
Engine tachometer:
90890-03113
Engine idling speed:
1,800 ~ 2,100 r/min
VALVE CLEARANCE INSPECTION AND
ADJUSTMENT
NOTE:
The valve clearance should be adjusted
G
when the engine is cool to the touch.
The piston must be at Top Dead Center
G
(T.D.C.) on compression stroke to check or
adjust the valve clearance.
1. Remove:
Seat
G
Fuel tank
G
Refer to "SEAT, FUEL TANK AND
SIDE COVERS" section in the CHAP-
TER 4.
2. Drain:
Coolant
G
Refer to "COOLANT REPLACEMENT"
section.
3 - 19
INSP
ADJ