Install the carburetor breather hoses to the
carburetor so that the hoses do not bend near
where they are installed.
Accelerator pump timing adjustmet
In order for the throttle valve height a to
achieve the specified value, tuck under the
throttle valve plate 1 the rod 2 etc. with the
same outer diameter as the specified value.
Install the projections a on the carburetor joint
between the clamp ends.
Install the projection a on the cylinder head
between the carburetor joint slots b.
4 - 18
Carburetor breather hose 1
Throttle valve height:
1.50 mm (0.059 in)
Fully turn in the accelerator pump adjust-
ing screw 3.
Check that the link lever 4 has free play
b by pushing lightly on it.
Gradually turn out the adjusting screw
while moving the link lever until it has no
more free play.
Carburetor joint 1
3 Nm (0.3 m · kg, 2.2 ft · lb)