For Dynamic Ip Address - Xerox WorkCentre 5735 System Administrator Manual

8. Touch [Subnet and Gateway], the Subnet and Gateway screen displays.
a. For IP Gateway, touch each octet under the title and enter IP Gateway address using the
numerical keypad.
b. Repeat this process for the Subnet Mask. When you are finished, touch [Save] to accept the
changes and return to the TCP/IP Settings screen.
c. Touch [Close] to return to the TCP/IP screen.
9. Touch [HTTP/IPP Enablement], the HTTP/IPP Enablement screen displays.
a. For Protocol, ensure Enable is selected. If not, touch [Enable].
b. Touch [Save], then touch [Close] to return to the Tools pathway.
10. Touch [TCP/IP-Line Printer], the TCP/IP - Line Printer screen displays.
a. Touch [Enable], to enable the option.
b. If you wish to change the LPR port for your device, touch the port number area and enter the
desired port number using the numerical keypad.
Note: You can change the port number at which your device will accept LPR print jobs. It is
recommended that you do this ONLY with extreme caution as most LPR spoolers are set to send
print jobs to the default port of 515.
c. Touch [Save] to return to the TCP/IP screen.
d. Touch [Close] to return to the Tools pathway.

For Dynamic IP Address

Installation via DHCP (Dynamic Host Configuration Protocol)
DHCP is enabled on the device by default. If the device is connected to the network the TCP/IP
information will be configured when the device is powered on and no further configuration is required.
Note: To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to
1. From the Tools pathway, touch [Network Settings].
2. Touch [Network Setup].
3. Touch [TCP IP].
4. Touch [TCP/IP Settings].
Note: All options under the IP Address/Host Name section will be grayed out until DHCP is
deselected in the Dynamic Addressing section. Follow the next step to disable DHCP and access
these options if required.
5. Touch [Automatic Addressing], by default, DHCP will be selected. Select the required dynamic
addressing method [BOOTP], [DHCP], or [RARP].
Note: To give the device a static IP Address, touch [Disabled] to disable Automatic Addressing.
Touch [Enabled].
a.
b. Touch [Save].
6. Touch [HTTP/IP Enablement], the HTTP/IP Enablement screen displays.
a. For Protocol, ensure Enable is selected. If not, touch [Enable].
Access Tools Pathway as a System Administrator
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
Windows 2000/2003/XP/Vista Environment
System Administrator Guide
on page 18.
71