Windows Using Microsoft (R) Networking; Netbios Over Ip - Xerox WorkCentre 5735 System Administrator Manual

Windows using Microsoft

NetBIOS over IP

Information Checklist
Before starting the procedure, ensure the following items are available or tasks have been performed:
• An existing operational network utilizing the TCP/IP protocol.
• A Static IP Address for the machine.
• A Subnet Mask Address for the machine.
• A Gateway Address for the machine.
• A Host Name for the machine.
• Ensure device is connected to the network with an Ethernet Cable.
• The CentreWare Print and Fax Drivers CD (delivered with your machine).
At the Machine
Note: To configure this feature or these settings access the Tools pathway as a System
Administrator. For details, refer to
1. From the Tools pathway, touch [Network Settings].
2. Touch [Network Setup].
3. Touch [TCP/IP].
4. Touch [TCP/IP Settings].
In the TCP/IP Settings screen:
5.
a. Touch the [Automatic Addressing] button.
b. Touch [Disabled].
c. Touch [Save].
6. Touch [IP Address/Host Name], in the IP Address/Host Name screen:
a. For IPv4 Address, touch each octet and enter the IP address using the numerical keypad.
b. For Host Name, touch detail bar.
c. Enter Host Name using the on-screen keyboard. To access more characters, touch [123] on
the user interface.
d. Touch [Save], then touch [Save] to return to the TCP/IP Settings screen.
Touch [Subnet and Gateway], in the Subnet and Gateway screen:
7.
a. For IP Gateway, touch each octet under the title and enter IP Gateway address using the
numerical keypad.
Repeat this process for the Subnet Mask. When you are finished, touch [Save] to accept the
b.
changes and return to the TCP/IP Settings screen.
c. Touch [Close] to return to the TCP/IP screen.
(R)
Access Tools Pathway as a System Administrator
WorkCentre™ 5735/5740/5745/5755/5765/5775/5790

Windows using Microsoft (R) Networking

Networking
System Administrator Guide
on page 18.
79