Snmp Advanced Settings - Xerox WorkCentre 5735 System Administrator Manual

Network Configuration
b. If you want to reset to the default Password, click on the [Reset] button.
Note: This account allows Xerox Clients and Drivers a limited amount of access to objects on the
device. If the device does not have SNMP v1/v2c enabled, and does not have this account
enabled, Xerox SNMP based clients will not be able to communicate with it. The default passwords
should be used, unless the passwords have been changed on the client.
c. Click on the [Save] button to save changes and return to the SNMP page.
8. In the Authentication Failure Generic Traps area:
a. Check the [Enable] checkbox to enable Authentication Failure Generic Traps to generate a
trap for every SNMP request by the device which contains an invalid community name.
Note: When the Authentication Failure Generic Trap is enabled, this machine will generate a trap
for every SNMP request that is received by the machine which contains an invalid community
name.
9. Click on the [Apply] button to save changes, or click on the [Advanced Settings] button to add or
edit an IP or IPX Address. For further information refer to
10. Click on the [OK] button when you see the message "Properties have been successfully
modified".

SNMP Advanced Settings

To Add or Edit an IP Address:
The System Administrator can add or delete IP and IPX Addresses for the Network Management
Workstations that receive Traps from the device.
Note: To configure this feature or these settings access the Properties tab as a System
Administrator. For details, refer to
1. From the Properties tab, click on the [Connectivity] link.
Click on the [Protocols] link.
2.
3. Select [SNMP] in the directory tree.
4. From the SNMP page, click on the [Advanced Settings] button.
5. To add or edit an IP Address, in the Trap Destination Addresses area, click on the [Add IP
Address] button or the [Edit] button for the required address.
6. In the Required Information area:
a. For [IP Address], enter the IP destination address of the SNMP manager that you are setting
up to receive traps for.
b. For [UDP Port Number], enter port number for the UDP destination port of the SNMP
manager that you are setting up to receive traps for.
c. For [SNMP Version], select the SNMP version that matches the SNMP manager with which
the device is communicating with.
7. In the Traps area:
a. The [TRAP Community Name] will display the default value for the TRAP Community Name.
b. For [Traps to be Received], check the checkbox for the type of traps sent by this device to the
Destination Address indicated by the IP Address and UDP port number entered by the user.
The choices are:
104 WorkCentre™ 5735/5740/5745/5755/5765/5775/5790
System Administrator Guide
Access Internet Services as System Administrator
SNMP Advanced Settings on page 104.
on page 24.