Error Message And Alarm - AND Check Weighing Indicator AD-4404 Instruction Manual

8.24. Error Message and Alarm

8.24.
8.24. 8.24.
When the indicator detects an error in the weighing system, an error message is
displayed, alarm sounds and the error status is output to the control I/O.
Press the ESC key to clear the message.
If there is another error after pressing the ESC key to clear first message, the second
error message is displayed.
The error number can be output from the BCD output of OP-01 or the serial interface.
Clear the error with the terminal of the control I/O that is specified to
If there are multiple errors, the prior error is cleared first.
Kind of error
Error message is displayed
Kind of Alarm and Error
There is the following priority.
Weighing sequence error
SQ.ERR
Kind
Check
weighing
sequence
error
SQ.ERR
Error Message and Alarm
Error Message and Alarm Error Message and Alarm
Error no.
Stop key
<
No.
When the weighing can not continue, a message is displayed and the
sequence is stopped. Cope with cause and restart the weighing.
The sequence pauses.
0
Cope with cause and restart the sequence.
Safety check can not be completed.
1
Check the safety.
Duplication has occurred.
2
Increase the interval between the articles.
There is a conflict in the setpoints
3
Check setpoint
There is foreign matter on the weighing conveyor.
4
Remove the foreign matter to start the sequence.
The article includes foreign matter.
5
Check it.
A crush error has occurred due to a fast conveyor.
6
Increase the interval between the articles.
Weighing error
SQ.ERR SQ.ERR
SQ.ERR SQ.ERR
Over or under amount in
the result
<
Zero error Alarm 1
ZR.ERR
ALARM 1
Description
Page 70
Error reset
Error no.
Alarm 1
SQ.ERR SQ.ERR
SQ.ERR SQ.ERR
ALARM 1 ALARM 1
ALARM 1 ALARM 1
Out of range
Principle alarm links, when
multiple alarm is active.
<
Alarm 2
ALARM 2
44
[ ].
Error no.