AND Check Weighing Indicator AD-4404 Instruction Manual page 106

When alarm number and error number of
function of the terminals are as follows:
A1 Sequence error
number
A2
A3
A4
A5 Zero error
number
A6
A7
A8
A9 Alarm 1 number
A10
A11
A12
A13 Alarm 2 number
A14
A15
A16
A17
A18 Print strobe
A19 Common ground
A20 Frame ground
Communication Modes
There are the following modes. The mode can be selected at
[01f- 3].
Stream Mode of [01f- 3] [1]
The data is output at every display update. If the data can not be output completely
due to a slow baud rate, the data is output at the next update.
Auto Print Mode of [01f- 3] [2]
The data is printed at judgement automatically.
Manual Print Mode of [01f- 3] [3]
When the preset print key is pressed or terminal is connected, data is output.
Jet Steam Mode of [01f- 3] [4]
The weighing data and state are output 100 time/s. The data is the gross or net value.
The format is the same as command RGRS or RNET.
Set baud rate to 38400 bps.
Set the baud rate to 38400 bps. If another baud rate is used, mis-sampling may occur.
Output data is repeated according to the number of
genf-3
divider
[
1 B1
4 B2
Error B3
B4
1 B5
4 B6
Error B7
B8
1 B9
4 B10
Error B11
B12
1 B13
4 B14
Error B15
B16
B17
B18
B19
B20
].
Page 104
[01f- 1] [10] are output, the
Output mode
Sequence error
number
Zero error number
Alarm 1 number
Alarm 2 number
Hold input
Common ground
Frame ground
Sampling frequency
2
8
2
8
2
8
2
8
Communication mode
AD-4404