Remote Operation - AND Check Weighing Indicator AD-4404 Instruction Manual

10.5. Remote Operation

10.5.
10.5. 10.5.
This mode can read and write the parameters of the function list, the code data and
calibration data.
The built-in RS-485, RS-422/485 (OP-03) or RS-232C (OP-04) is used for remote
operation.
It is necessary to install the remote setup program in the computer or controller
before use. Refer to http://www.aandd.co.jp
Refer to the instruction manual for details of the program.
Caution
Do not download data during a weighing operation.
Do not turn off the indicator during down load.
Remove all connections to prevent an irregular operation.
Maintain the power supply during the remote setup operation.
Entering the Remote Operation Mode
Step 1 Press and hold the ENTER key and press the
menu in a weighing mode.
Step 2 Select the menu
Select the menu
Category address: [Function] - [Set function] - [SystemMgmt] - [RemoteSetup]
Step 3 Select a menu using the
Data
Menu:
Data
Step 4 If is selected, press
key, ENTER key.
Step 5 Press the ESC key to return to weighing mode.
Advise
The following RS-232C to RS-485 converter can be used.
AD-4404
Remote Operation
Remote Operation Remote Operation
SystemMgmt
RemoteSetup
key, ENTER key.
Software
or
Yes
key to display the
using the key, ENTER key.
using the key, ENTER key.
to down load the data using the
Page 123