Referring Parameters - AND Check Weighing Indicator AD-4404 Instruction Manual

11.2. Referring 11.2.
11.2. 11.2.
Use this mode to refer to the parameters in the weighing sequence.
The temporary parameters can be input and used concerning the digital filter and
weighing sequence timers in the weighing sequence.
[genf- 2]
[genf- 3]
[5q f-31] to [5q f-48]
The temporary parameters can be reset by the following operation.
When entering into standby mode.
When entering into calibration mode.
When entering into function setting of the menu.
Operation Example
Step 1 Press and hold the ENTER key and press the
Function
Step 2 Select
Refer function
Step 3 Enter
Step 4 Refer paremeters or input temporary parameters.
Step 5 Press the ESC key to return to the weighing mode several times.
Operation Example to Store Temporary Parameters
Step 1 Press and hold the ENTER key and press the
Function
Step 2 Select
Refer function
Step 3 Enter
Step 4 Input temporary parameters.
Step 5 Press the ESC key and enter into
Then the weighing mode stops and parameters are stored.
Step 6 Press the ESC key to return the normal stop mode.

Referring Parameters

Parameters
Referring Referring Parameters Parameters
Digital filtering
[Function] - [Function setting] - [General] - [Weighing]
Sampling frequency divisor
[Function] - [Function setting] - [General] - [Weighing]
Weighing sequence timers
[Function] - [Function setting] - [Sequence] - [Timer]
using the
using the ENTER key.
using the
using the ENTER key.
key to display the menu.
key and press the ENTER key.
key to display the menu.
key and press the ENTER key.
Set function
Page 126
using the and ENTER key.
AD-4404