Table of Contents
Advertisement
5060-00x
Error code table
Error code
9xx service errors
900 RIP Software
902 Service Engine Error 0
904 Engine Software
905 Engine Software
906 Engine Software
907 Engine Software
910 Trans Sensor
911 Trans Sensor
912 Trans Sensor
913 Trans Sensor
914 Trans Sensor
915 Trans Sensor
916 Trans Sensor
2-6
Service Manual
Action
Go to
"900 RIP Software Error" on page
General Engine Software Errors 902 through 908 indicate an
unrecoverable engine software error. The engine board may cause this
type of error. Turn the printer off and on to try and clear the error code. If
this does not fix the problem after several attempts, call your next level
support before replacing the engine board.
Interface violation by RIP—check all cabling and connections to the RIP
board. If no problem is found, replace the RIP board. See
removal" on page
4-70.
Interface violation by Paper Port Device—turn the printer off and on to try
and clear the error code. If this does not fix the problem after several
attempts, do the following:
Check each paper handling option to isolate which one is causing the
problem. If you do not find a problem with any of the options, replace the
engine board. See
"Engine board removal" on page
Engine RAM Error—replace the engine board. See
removal" on page
4-29.
Engine Flash Error—the engine board might be causing the error code.
Try the following:
Reflash the engine board with the correct level code. If this does not fix
the problem, replace the engine board. See
on page
4-29.
Tray 1 Transparency Sensor Error—replace Tray 1 autocompensator
assembly. See
"Autocompensator pick assembly removal" on
page
4-17. If this does not fix the problem, replace the engine board. See
"Engine board removal" on page
Tray 2 Transparency Sensor Error—replace Tray 2 transparency sensor
assembly. If this does not fix the problem, replace the engine board. See
"Engine board removal" on page
Tray 3 Transparency Sensor Error—replace Tray 3 transparency sensor
assembly. If this does not fix the problem, replace the engine board. See
"Engine board removal" on page
Tray 4 Transparency Sensor Error—replace Tray 4 transparency sensor
assembly. If this does not fix the problem, replace the engine board. See
"Engine board removal" on page
Tray 1 Transparency Sensor Error—replace Tray 1 autocompensator
assembly. See
"Autocompensator pick assembly removal" on
page
4-17. If this does not fix the problem, replace the engine board. See
"Engine board removal" on page
Tray 2 Transparency Sensor Error—replace Tray 2 transparency sensor
assembly. If this does not fix the problem, replace the engine board. See
"Engine board removal" on page
Tray 3 Transparency Sensor Error—replace Tray 3 transparency sensor
assembly. If this does not fix the problem, replace the engine board. See
"Engine board removal" on page
2-88.
"RIP board
4-29.
"Engine board
"Engine board removal"
4-29.
4-29.
4-29.
4-29.
4-29.
4-29.
4-29.
Advertisement
Table of Contents
