Table of Contents
Advertisement
Factory Defaults
The customer can restore either the network settings or the base printer settings to their factory default values.
When Restore Base is selected, non-critical base printer NVRAM settings are restored. When Restore Network
is selected, all network NVRAM settings are restored to their factory default settings. This option is only available
on models with an integrated network adapter. In either case, Restoring Factory Defaults is displayed after the
operation is selected.
Select Factory Defaults from the CONFIG MENU.
=Restore Base
=Restore Network
Note: Restore Network is only listed on models that have integrated network support.
Energy Conserve
When Energy Conserve is on, the customer does not have access to disable the Power Saver function. When
Energy Conserve is off, Disable appears as an additional menu item in the Power Saver menu. This setting only
affects the values that are displayed in the Power Saver Menu.
Select Energy Conserve from the CONFIG MENU.
=On*
=Off
ITU Alignment
This alignment is required anytime you replace the ITU Assembly.
1.
Select ITU Alignment from the CONFIG MENU.
A test page is printed.
2.
After the test page prints, enter alignment values for each alignment setting.
Example:
A Alignment
0*
On printed sheet:
Enter:
A Alignment
4
The alignment values range from -10 to + 10 in 0.5 increments (0*).
3.
Press Select to continue to the next alignment value.
4.
You will be prompted to continue through Test L, pressing Select to save each value.
5.
When the tests are done, press Go or Return to exit.
A __
Diagnostic aids
5060-00x
3-11
Advertisement
Table of Contents
