Table of Contents
Advertisement
5060-00x
Nip relief handle replacement
Removing the old nip relief handle
1.
Remove lower left side covers to gain access to the nip relief handle.
2.
Remove waste toner container.
3.
Reinsert paper tray into printer.
If any fragments fall into the printer they should land in the paper tray and be easy to remove.
4.
Remove the broken pieces of old nip relief handle.
a.
Pull up the upper piece of handle to raise the nip relief link (A) and rotate the upper piece of handle
90° clockwise to free it from the link (A).
b.
Using a side cutter, cut the lower piece of the handle free from the post.
Some scarring of the post is expected, but be careful not to damage the post.
A-18
Service Manual
Advertisement
Table of Contents
