Table of Contents
Advertisement
5060-00x
User primary
message
51 Defective Flash
52 Flash Full
53 Unformatted Flash
54 Std Par ENA
Connection Lost
54 Std Network
Software Error
54 Network x
Software Error
54 Serial Option x
Error
2-38
Service Manual
User secondary
Explanation
message
This message is displayed when the printer detects a
defective flash.
Press Go to clear the message
The flash is marked as bad and normal operation continues.
No flash operation is allowed until the flash problem is
resolved.
This message is displayed when there is not enough free
space in the flash memory to hold the resources that have
been requested to be written to flash.
Note: The following action deletes all downloaded Fonts and
Macros not written to flash:
• Press Go to clear the message and continue processing
• Press Menu to access the Busy/Waiting Menu.
The following functions may be available:
• Cancel Job
• Reset Printer
• Reset Active Bin
• Check Supply Levels
Note: Menu Lockout does NOT prevent access to the Busy/
Waiting Menu.
This message is displayed when the printer detects an
unformatted flash at POST.
Press Go to clear the message.
The flash is marked bad and normal operation continues.
Flash operations are not allowed until the flash is formatted.
This message is displayed when the printer detects during
POST that the connection to an ENA has been lost. Once a
connection is initially established, a printer setting is
modified to 54 Par x ENA to note a connection exists. Each
time the power is cycled on, the connection is lost.
This message is displayed when the RIP software detects
that a network port is installed but cannot establish
communications with it.
Press Go to clear this message.
The printer disables all communications to the associated
network interface. No data may be received or sent from or
to the associated interface. The user can program new
firmware in the network using the parallel port after this
message clears.
This message is displayed when a serial error, either
framing, parity or overrun, is detected on the specified
(option x) serial port. This usually means the serial port is
not set up correctly.
Press Go to clear the message and continue processing the
print job.
Note: If the print job does not print correctly, make sure that
the correct cable is being used. If you still have a problem go
to Serial Port Service Check.
the print job.
Advertisement
Table of Contents
