Error Code Table - Lexmark 13P0150 - C 750dtn Color Laser Printer Service Manual

Symptom
Fuser Problem - Fuser running too hot
Fuser Problem - Excessive Fuser Drive Motor
Assembly Noise
Paper Jams in base printer
"Close Door" displays constantly, unable to clear
the message, POR incomplete

Error Code Table

Error code
900 RIP Software
902 Engine Software
903 Engine Software
904 Engine Software
905 Engine Software
906 Engine Software
907 Engine Software
908 Engine Software
910 Trans Sensor
5060-XXX
Action
Go to the
page 2-83.
Go to "Excessive Fuser Drive Motor Assembly
Noise" on page
Go to the
page 2-97.
Go to "Cover Open/HV Interlock Switch Service
Check" on page
Action
Contact your next level support.
General Engine Software Errors 902 through 908 indicate an
unrecoverable engine software error. The Engine Board may cause
this type of error. Turn the printer off and on to try and clear the
error code. If this does not fix the problem after several attempts,
call your next level support before replacing the Engine Board.
Paperport link driver by the RIP error - The Engine Board may
cause this type of error. Turn the printer off and on to try and clear
the error code. If this does not fix the problem after several
attempts, call your next level support before replacing the Engine
Board.
Interface violation by RIP - Check all cabling and connections to
the RIP board. If no problem is found, replace the
page 4-11.
Interface violation by Paper Port Device - Turn the printer off and
on to try and clear the error code. If this does not fix the problem
after several attempts, do the following:
Check each paper handling option to isolate which one is causing
the problem. If you do not find a problem with any of the options,
replace the "Engine Board" on page
Engine RAM Error - Replace the
Engine Flash Error - The Engine Board might be causing the error
code. Try the following:
Reflash the Engine Board with the correct level code. If this does
not fix the problem, replace the
Engine ASIC Error - Replace the
Tray 1 Transparency Sensor Error - Replace Tray 1 Transparency
Sensor Assembly. If this does not fix the problem, replace the
"Engine Board" on page
"Hot Fuser Service Check" on
2-85.
"Paper Path Service Check" on
2-87.
4-13.
"Engine Board" on page
"Engine Board" on page
"Engine Board" on page
4-13.
Diagnostic Information
"RIP Board" on
4-13.
4-13.
4-13.
2-3