Lexmark C 750 Quick Reference

Lexmark C750 5 Place the paper against the back left corner of the tray, print
side down. Do not bend or wrinkle the sheets.
Quick Reference
Note:
Loading a 500-sheet tray
Follow these instructions to load the standard tray (tray 1) and all
500-sheet trays.
1 Remove the tray.
2 Squeeze the front guide lever and slide the guide to the front of
the tray.
3 Squeeze the side guide lever and slide the guide to the correct
position for the size paper you are loading.
Icons along the back of the tray indicate paper sizes.
6 Squeeze the front guide lever and slide the guide until it lightly
touches the stack of paper.
4 Flex the sheets back and forth to loosen them, and then fan
them. Do not fold or crease the paper. Straighten the edges of
the stack on a level surface.
7 Reinstall the tray.
Loading a 2000-sheet tray
Follow these instructions to load a 2000-sheet tray. Do not load any
Do not exceed the maximum stack height. Overfilling
print media other than paper in the 2000-sheet tray.
the tray may cause a paper jam.
1 Pull open the tray.
2 Squeeze the side guide lever, lift the guide, and place it into
the appropriate slot for the size paper you are loading.
3 Squeeze the two front guide levers and slide them to the
correct position for the size paper you are loading.
4 Slide the bottom support toward the front of the tray until it Loading the multipurpose feeder
touches the front guide.
The multipurpose feeder accepts plain paper, envelopes,
transparencies, card stock, and labels.
1 In your word processor, spreadsheet, browser, or other
application, select
2 Click Properties
application) to view the printer driver settings.
3 Select MP Feeder
4 Select your media type (envelopes, transparencies, glossy
paper) from the Media Type list box.
5 Click OK
6 Go to the printer. A display message prompts you to Load
5 Flex the sheets back and forth to loosen them, and then fan
Manual.
them.
7 Open the multipurpose feeder.
6 Place the paper against the back left corner of the tray, print
side down. Do not load bent or wrinkled paper.
Note: Do not exceed the maximum stack height. Overfilling
the tray may cause a paper jam.
7 Close the tray.
8 Reach down into the feeder. Squeeze the paper guide lever
and slide the guide all the way towards the front of the printer.
File Print .
(or Options , Printer , or Setup depending on the
from the Form Source list box.
, and then send your print job as usual.
9 Place paper print side up, or envelopes flap side down in the
feeder. Push the media in as far as it will go without forcing it.
Note: Arrange the media correctly for the size, type, and print
method you are using. Do not overfill.
© Copyright 2001 Lexmark International, Inc. All rights reserved.
This document is printed on recycled paper. 8/01
E.C. 2B0151
Printed in U.S.A.
P/N 10B2639