Error Code - Lexmark 13P0195 - C 750dn Color Laser Printer Service Manual

5060-00x

130 Error code

Hot roll did not reach the correct standby temperature
Step Action and questions
1 Measure the voltage on connector J10-11 on the
engine board. The voltage should measure
approximately +0.13 V dc to +0.64 V dc as the hot roll
lamp turn on and off.
Is the voltage correct?
2 Remove the fuser from the printer. Check continuity of
the hot roll lamp by measuring between pins 1 and 2 on
the AC fuser connector on the fuser assembly.
Is there continuity?
3 Make sure the hot roll lamp is installed correctly.
Is the lamp installed correctly?
4 Carefully remove the lamp from the fuser assembly,
being careful to only handle the lamp by the ceramic
end pieces and not by the glass envelope.
Warning: Use caution when handling the lamp as it is
easily broken.
Check continuity of the lamp.
Is there continuity?
5 Reinstall the fuser assembly. Watch to see if the lamps
turn on and off as the lap heats up.
Do the lamps turn on and off?
Turn the printer on and off and allow it to reach Ready.
6
Note: The printer may not complete POR and continue
to display a 130 error.
Remove the fuser assembly from the printer and
measure the voltage on connector J10-6 on the engine
board. The voltage should measure approximately
+3.3 V dc.
Is the voltage correct?
7 Measure the voltage on pin 6 of the fuser DC control
connector. The voltage should measure approximately
+3.3 V dc.
Is the voltage correct?
2-50
Service Manual
Yes No
Replace the fuser Go to step 2
assembly. See
"Fuser assembly
removal" on
page 4-31
Go to step 3 Go to step 4
Go to step 4 Install the lamp
correctly.
Replace the fuser Replace the lamp.
assembly. See
"Fuser assembly
removal" on
page 4-31.
Go to step 6 Replace the LVPS
assembly. See
"Low voltage
power supply
(LVPS) removal"
on page
Go to step 7 Replace the engine
board. See
"Engine board
removal" on
page
Replace the fuser Replace the LVPS
assembly. See assembly. See
"Fuser assembly "Low voltage
removal" on power supply
page 4-31. (LVPS) removal"
on page
4-38.
4-29.
4-38.