Table of Contents
Advertisement
5060-00x
Error code
960 RAM Memory Error
961 RAM Memory Error
962 RAM Memory Error
963 RAM Memory Error
964 Emulation Error
975 Standard Network
or
Network Card x
976 Standard Network
978 Standard Network
or
Network Card x
979 Standard Network
or
Network Card X
980 <device> comm
981 <device> comm
982 <device> comm
2-8
Service Manual
Action
RAM soldered on board is bad. Replace the RIP board. See
removal" on page
4-70.
Errors 961 through 963 indicate that a memory error has occurred on
RAM x in slot x installed on the RIP card. If available, switch memory
from the failing slot with one from a non-failing slot to see if this fixes the
problem. If it does not fix the problem, replace the RIP board. If another
RAM option is not available, replace the RAM that is failing. If this does
not fix the problem, replace the RIP board. See
page
4-70.
Download Emulation CRC failure has occurred.
The following actions may be taken:
1. Disable Download Emulation.
2. Program the download emulation into the code overlay SIMM, again.
3. If the problem is not resolved, replace the code overlay SIMM and
download emulation, again.
Unrecognizable network errors 975 through 979 indicate a failure with
the standard network port located on the RIP board or a network card in
the specified slot x, x=1, 2 or 3. If unable to clear the error message,
check the following:
• If installed, check network card for correct installation.
• If correctly installed, replace the network card.
• If a network card is not installed, replace the RIP board.
Unrecoverable software or error in network port. Network card x. If
unable to clear the error message, check the following:
• If installed, check network card for correct installation.
• If correctly installed, replace the network card.
• If a network card is not installed, replace the RIP board.
Bad checksum while programming network card x port.
Flash parts failed while programming network card x port.
Engine is experiencing unreliable communications to the specified
device.
Engine protocol violation detected by the specified device.
• Engine
• Duplex option
• Tray x (where x=1,2,3,4, or 5)
• Output bin (where x=1,2,3, or 6)
Note: This message is used for single bin output devices.
• Bin x to y (where x to y=1 to 5).
Note: This message is used for multiple bin output devices.
Communications error detected by the specified device.
• Engine
• Duplex option
• Tray x (where x=1,2,3,4, or 5)
• Output bin (where x=1,2,3, or 6)
Note: This message is used for single bin output devices.
• Bin x to y (where x to y=1 to 5).
Note: This message is used for multiple bin output devices.
"RIP board
"RIP board removal" on
Advertisement
Table of Contents
