5060-00x
Developer HVPS board removal
See
"Developer HVPS board" on page 7-38
1.
Remove the RIP board shield assembly. See
2.
Remove the four screws type
board.
3.
Disconnect the HVPS to RIP board cable (C), the cartridge signature button cables (D) and the doctor
blade cable (E) from the developer HVPS board and remove the board.
Installation note:
1.
Disconnect the cable between boards.
2.
Install the large board by attaching the bottom screws loosely, attach the top screws, then tighten the
bottom screws.
3.
Connect the boards
4.
Install the small board in the same manner as the large board.
4-28
Service Manual
"323"
(A) and four screws type
B(121)
C
for the part number.
"RIP board shield assembly removal" on page
"121"
A323)
D
(B) that mount the developer HVPS
E
4-71.