Table of Contents
Advertisement
5060-00x
Paper size sensing assembly removal
See
"Paper size sensing assembly" on page 7-57
Note: The paper size sensing assembly contains components that easily fall apart as you remove the assembly.
Be careful not to lose any of the components.
1.
Remove the rear cover. See
2.
Remove the rear fan cover. See
3.
Remove the engine board shield. See
4.
Open the waste toner container door and slide the container out.
5.
Remove the paper size sensor assembly screw type
Pick rolls
See
"Pick rolls (2 each per package)" on page 7-24
Front roll
1.
Wipe any toner or debris from the bottom pan to avoid contaminating the pick tires.
2.
Pull the pick assembly down into the bottom pan and press the latch to remove the tire.
Note: Do not attempt to remove either the shaft or the clutch races.
4-48
Service Manual
for the part number.
"Rear cover removal" on page
"Rear fan cover removal" on page
"Engine board shield removal" on page
"323" on page 4-3
for the part number.
4-8.
4-8.
4-30.
(A).
Advertisement
Table of Contents
