Table of Contents
Advertisement
5060-00x
S2 sensor late
•
2D 11—S2 sensor late
•
2D 03—S2 sensor late
Note: See
"Printer sensors" on page
Step
Action and questions
1
Check the tray for proper edge guide setting and media
loading. Edge guides should be adjusted against edge
of media. Media should be fanned and lay flat in the
tray.
Is the media properly loaded in the tray?
2
Check the pick tires for contamination or wear.
Are pick tires worn or contaminated?
3
Check for obstructions in the paper path.
Is the paper path obstructed?
4
Is the inner deflector out of position?
5
Is the autocompensator damaged or defective?
6
Perform the
the S2 sensor.
Does the S2 sensor pass the test?
S2 or narrow media sensor made early
•
2D 0F—S2 sensor early
•
2D 02—S2 sensor early
•
2D 05—Narrow media sensor early
Note: See
"Printer sensors" on page
Step
Action and questions
1
Check tray for the edge guide setting and media
loading. Edge guides should be adjusted against edge
of media. Media should be fanned and lay flat in the
tray.
Is the media properly loaded in the tray?
2
Media may not have been cleared from a previous jam.
Is media in paper path?
2-68
Service Manual
5-3.
"BASE SENSOR TEST" on page 3-29
5-3.
Yes
Go to step 2
Replace the pick
tires. See
"Pick
rolls" on
page
4-48.
Clear the
obstruction.
Correct the
deflector position.
Go
to"Autocompensa
tor service check"
on page 2-114
on
Call your next level
of support.
Yes
Go to step 2
Clear the paper
path.
No
Properly load
media.
Go to step 3
Go to step 4
Go to step 5
Go to step 6
See
"S2 or narrow
media sensor
obstructed" on
page
2-67.
No
Properly load
media.
Call your next level
of support
Advertisement
Table of Contents
