Table of Contents
Advertisement
Autocompensator pick assembly removal
1.
Remove all cartridges.
2.
Remove the ITU. See
3.
Remove tray 1.
4.
Remove the second transfer roll. See
5.
Remove the transfer plate. Lifting and rotating the right edge of the plate up to a 45° angle will release the
transfer plate. Remove the grounding strap (A) attached to the bottom of the transfer plate.
6.
Remove the black mylar piece by removing the two screws (B) or cutting the cable tie.
"ITU assembly removal" on page
"Second transfer roll removal" on page
4-37.
B
Repair information
5060-00x
4-79.
4-17
Advertisement
Table of Contents
