Upload; Config Ipif System - D-Link DES-1210-08P Reference Manual

5 Command Line Interface
download
<path_filename>
Parameters
Parameter
firmware_fromTFTP
cfg_fromTFTP
<ipaddr>|<ipv6addr>
path_filename

upload

The upload command is used to upload the firmware file or a Switch configuration file to a TFTP
server.
Syntax
upload
{firmware_toTFTP
<path_filename>
Parameters
Parameter
firmware_toTFTP
cfg_toTFTP
<ipaddr>|<ipv6addr>
path_filename

config ipif system

The config ipif system command sets the IP address of the switch.
Syntax
config ipif
address> | dhcp | bootp}
config ipif system {ipv6 ipv6address <ipv6networkaddr> | dhcpv6_client
[enable | disable]}
Parameter
Parameter
ipaddress
address>
mask>
gateway <gw-address>
dhcp
{firmware_fromTFTP
Description
Download and install new firmware on the Switch from a TFTP server.
Download a switch configuration file from a TFTP server.
The IPv4 or IPv6 address of the TFTP server.
The filename of the firmware or switch configuration file on the TFTP
server. You need to specify the DOS path if the file is not at the root
directory of the TFTP server.
Note: Switch will reboot after restore and
all current configurations will be lost
Description
Upload the firmware on the Switch from a TFTP server.
Specifies that the Switch's current settings will be uploaded to the TFTP
server.
The IPv4 or IPv6 address of the TFTP server.
The filename of the firmware or switch configuration file on the TFTP
server. You need to specify the DOS path if the file is not at the root
directory of the TFTP server.
system
{ipaddress
Description
<ip-
The IP address and subnet mask to be created. Users need to specify
<subnet-
the address and mask information using the traditional format (for
example,10.1.2.3/255.0.0.0).
The IP address of the router or gateway.
Allows the selection of the DHCP protocol for the assignment of an IP
DES-1210 Series Switch Web UI Reference Guide
| cfg_fromTFTP}
| cfg_toTFTP}
<ip-address>
86
{<ipaddr>|<ipv6addr>}
{<ipaddr> |
<subnet-mask> gateway
<ipv6addr>}
<gw-