Table of Contents
Advertisement
Video Processor Module - Video Processor Registers - Function 4
Table 7-9. F4BAR0+Memory Offset: Video Processor Configuration Registers (Continued)
Bit
Description
22:21
REFEN[1:0] (Enable FrameRef). Enables the externally provided FrameRef to initialize the horizontal and vertical counters
and/or the internal frame counter.
00: No initialization.
01: The horizontal and vertical counters are initialized to the values in HPhase and VPhase.
10: The internal frame counter is set to 3.
11: The horizontal and vertical counters are initialized to the values in HPhase and VPhase and the internal frame counter
is set to 3,
20:11
VPHASE (Vertical Phase). Defines the phase (i.e., the number of lines) between the internal vertical counter and the exter-
nally provided FrameRef.
If REFEN[0] (bit 21) = 1, the vertical counter in the video timing generator is set to this value when FrameRef is asserted.
Valid values are:
PAL:
1 to 625
NTSC:
1 to 525
10:0
HPHASE. (Horizontal Phase). This bit field defines the phase (i.e., the number of pixels) between the internal horizontal
counter and an externally provided FrameRef.
If REFEN[0] (bit 21) = 1, the horizontal counter in the video generator is set to this value when FrameRef is asserted.
The counter is split into two parts, a 10-bit "half-line" counter and a single bit "line-half". The half-line counter counts half a
line and is reset. When the half-line counter is reset, the line-half indicator toggles.
In PAL mode, there are 1728 27 MHz clock cycles per line. In this mode, the half-line counter counts 0 to 863. To set the hor-
izontal phase to a value HP between 0 and 1727, HPHASE[10] is set to HP/864 and HPHASE[9:0] is set to HP%864.
In NTSC mode, there are 1716 27 MHz clock cycles per line, so HPHASE[10] is set to HP/858 and HPHASE[9:0] is set to
HP%858.
Offset C04h-C07h
31
Anlg (Analog Line). When set, the horizontal blanking interval is increased to comply with relevant specification.
30
TV DAC Mode Bit 2. See TV DAC Mode Bits [1:0] (F4BAR0+Memory Offset C08h[4:3]).
29:20
Reserved.
19
Y2BP (Luminance Bypass). Luminance 2x oversampling bypass.
0: Disable.
1: Enable.
18
C2BP (Chrominance Bypass). Chrominance 2x oversampling bypass.
0: Disable.
1: Enable.
17:16
CFS (Chrominance Lowpass Filter Select). Selects one of three frequency responses for the chrominance lowpass filter:
00 or 01: Filter is bypassed.
10: 1.3 MHz lowpass for composite video output.
11: 1.8 MHz lowpass for S-Video output.
15:8
HUE (Hue Offset). Defines a fixed hue offset which is added to the subcarrier phase during the active video portion of the
line. The value programmed is: hue (degrees) / 256.
7:0
SCPHASE (Subcarrier Phase). Defines the subcarrier phase at the start of a two-frame sequence (NTSC) or four-frame
sequence (PAL).
The number is: phase (in degrees) / 256.
AMD Geode™ SC1200/SC1201 Processor Data Book
Timing & Encoder Control 2 Register
32579B
Reset Value: 1FF00000h
355
Advertisement
Table of Contents
