To Configure Disconnected Extensions; Automatic Line Selection - Mitel 3000 Administrator's Manual

•
From the Programming Extension, press the PROGRAM Key
•
Press the Scroll Down Key ( ) until 'System programming' is displayed
•
Select 'System programming'
•
Enter the System Programming Password
•
Select 'Lines'
•
Press the Scroll Down Key ( ) until 'Equipped Lines' is displayed
•
Select 'Equipped lines'
•
Select the lines you wish to equip or unequip. Equipped lines are denoted by a ♦.
Unequipped lines are denoted by a ◊.
Press the Hands-free Key to finish programming.

To configure disconnected extensions

The system assumes that all available extension interfaces have devices connected to them.
If an extension interface does not have a device connected, ensure correct system operation
by disconnecting the extension interface in system programming, as follows
•
From the Programming Extension, press the PROGRAM Key
•
Press the Scroll Down Key ( ) until 'System programming' is displayed
•
Select 'System programming'
•
Enter the System Programming Password
•
Select 'Extensions'
•
Press the Scroll Down Key ( ) until 'Extension disconnect' is displayed
•
Select 'Extension disconnect'
•
Select the extensions you wish to connect or disconnect. Disconnected extensions
are denoted by a ♦.
Press the Hands-free Key to finish programming.
Note: When a Feature phone is connected to an extension interface that is programmed as
disconnected, the Feature phone display may appear as if the Feature phone is connected.
However, when the Handset is lifted a busy tone is heard and no options will be displayed.

AUTOMATIC LINE SELECTION

This feature is programmable off or on. When programmed as "off", the user must dial the line
access code after going off hook before an external line is selected. Default is set "off"
When Automatic Line selection is turned on when an extension goes off hook and dials a
number, a free line is selected automatically and the digits are sent to line. Internal calls are
made by selecting the internal call menu on Featurephone or by pressing Hookflash and
dialling the extension number if an analogue phone (POTS) is used.
The Automatic Line Selection feature seizes the line from Outgoing group 1 (0). If this line is
busy, it will take automatically the next free outgoing group.
To program the Automatic Line Selection feature:
•
From the programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "System".
•
Press the Scroll Down key ( ) until "Auto Line Selection" is displayed.
•
Select "Auto Line Selection On".
Press the speakerphone key to finish programming.
Mitel 3000 Australia Administrator's Manual
99