Mitel 3000 Australia Administrator's Manual
Answering Machine Mailbox programming
Answering Machine Mailbox Programming when a PRI is
Programmed
System voice mailbox is programmed as follows:
•
From the Programming Extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until 'System Programming' is displayed.
•
Select 'System Programming'.
•
Enter the System Programming Password
•
Select 'Lines'.
•
Press the Scroll Down key ( ) until 'Answering Machine' is displayed.
•
Select 'Answering Machine'.
•
Select the lines to be answered by the Answering Machine. The lines that will be
answered are indicated by a '♦'.
Press the speakerphone key to finish programming.
Note: To activate this feature a voicemail card is required
Note: If PRI Access is selected all the available B-channels are answered by the System
Voice Mailbox. Lines 31 - 34 or Access 1 -2 are the back up Lines, if equipped.
Analogue/Basic Rate line backup
A single PRI Access providing up to 30 channels can be equipped. However two additional
Line modules can be equipped providing for up to four extra analogue/Basic Rate lines. The
maximum number of line interfaces that can be provided is 34, ( 30 channels and 4 PSTN
lines or 2 ISDN basic rate accesses).
Presentation of Lines on the Feature phones
Programmed Feature phone keys in Key system mode
The Feature phone keys are programmed with Lines 1-8 in the case of the Standard feature
phone and Lines 1-16 in the case of the Executive feature phone.
If the system is programmed with a PRI Access pressing Line 1 will request a B channel
from the network. The line offered may not be the first B Channel. However the Led
associated with Line 1 key will light on all Feature phones.
Any backup Lines equipped will be numbered Line 31 - 34 or Access 1 - 2.
If more than 16 Line keys are required the keys on a DSS console can be programmed. The
same procedure applies to these keys. In the case of PRI Access the network will determine
the B Channel.
Line presentation in the Feature phone display
When a switch is equipped with PSTN Lines only the lines are presented as Line 1, Line 2
etc on the Feature phone display when an external consultation, transfer or conference is
invoked.
In the case of PRI the numbering will be the same, but when a line is selected the network
will determine which B-Channel is used. Any backup Lines will be numbered Line 31 - 34.
124