To Configure Disconnected Extensions; Automatic Line Selection; To Examine System Passwords - Mitel 3000 Administrator's Manual

Mitel 3000
Administrator's Manual

TO CONFIGURE DISCONNECTED EXTENSIONS

The system assumes that all available extension interfaces have devices connected to them. If an extension
interface does not have a device connected, ensure correct system operation by disconnecting the extension
interface in System Programming.
•
From the Programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Extensions".
•
Press the Scroll Down key ( ) until "Extension Disconnect" is displayed.
•
Select "Extension Disconnect".
•
Select the extensions you wish to connect or disconnect. Disconnected extensions are denoted by a
"♦".
Press the speakerphone key to finish programming.
Note: When a Feature Phone is connected to an extension interface that is programmed as disconnected,
the Feature Phone display can appear as if the Feature Phone is connected. However, when the handset is
lifted, a busy tone is heard and no options will be displayed.

AUTOMATIC LINE SELECTION

This feature is programmable off or on. When programmed as "off", the user must dial the line access code
after going off hook before an external line is selected. Default is set "off"
When Automatic Line selection is turned on when an extension goes off hook and dials a number, a free
line is selected automatically and the digits are sent to line. Internal calls are made by selecting the internal
call menu on Featurephone or by pressing Hookflash and dialling the extension number if an analogue
phone (POTS) is used.
The Automatic Line Selection feature seizes the line from Outgoing group 1 (9). If this line is busy, it will
take automatically the next free outgoing group.
To program the Automatic Line Selection feature:
•
From the programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "System".
•
Press the Scroll Down key ( ) until "Auto Line Selection" is displayed.
•
Select "Auto Line Selection On".
Press the speakerphone key to finish programming.
To turn Off the Automatic Line Selection feature follow the above steps and select the "Auto Line
Selection Off".

TO EXAMINE SYSTEM PASSWORDS

•
From the Programming extension, press the PROGRAM key.
•
Press the Scroll Down key ( ) until "System Programming" is displayed.
•
Select "System Programming".
•
Enter the System Programming Password and select "Extensions".
•
Press the Scroll Down key ( ) until "Examine Passwords" is displayed.
•
Select "Examine Passwords".
104