Mitel 3000 Australia Administrator's Manual
Programming Tone Dialling
On standard Analogue lines on Mitel 3000 the Tone dialling option is programmed. The
system sends digits dialled to the lines as tones rather than pulses.
•
From the Programming Extension, press the PROGRAM Key
•
Press the Scroll Down Key ( ) until 'System programming' is displayed
•
Select 'System programming'
•
Enter the System Programming Password
•
Select 'Lines'
•
Press the Scroll Down Key ( ) until 'PSTN programming' is displayed
•
Select 'PSTN programming'
•
Press the Scroll Down Key ( ) until 'Tone Dialling' is displayed
•
Select 'Tone Dialling'
•
The lines with Tone Dialling programmed are indicated with a ♦.
Programming Dialtone Detection
This feature is provided as a programmable option under PSTN programming and is enabled
to prevent the system from dropping the line when dial tone has not been detected. When
enabled dial tone is not detected and the line is released if no digit is dialled until the expiration
of the 'Dialling time-out timer'
•
From the Programming Extension, press the PROGRAM Key
•
Press the Scroll Down Key ( ) until 'System programming' is displayed
•
Select 'System programming'
•
Enter the System Programming Password
•
Select 'Lines'
•
Press the Scroll Down Key ( ) until 'PSTN programming' is displayed
•
Select 'PSTN programming'
•
Press the Scroll Down Key ( ) until 'Disable dialtone detect' is displayed
•
Select 'Dialtone detection' The lines with 'Dialtone detection' programmed are
indicated with a ♦
Routing calls to Phantom mailboxes
The Incoming ringing and CLI programming are modified so that calls can be routed directly to
Phantom Mailboxes. The addition of this programming means that some PSTN Lines can be
answered by Phantom Mailboxes. These can be programmed as message only boxes allowing
separate information only lines to be set up.
•
From the Programming Extension, press the PROGRAM Key
•
Press the Scroll Down Key ( ) until 'System programming' is displayed
•
Select 'System programming'
•
Enter the System Programming Password
•
Select 'Lines'
•
Press the Scroll Down Key ( ) until 'Incoming Ringing' is displayed
•
Select 'Incoming Ringing'
•
Select which Line and which mode you wish to use
•
Select 'Other' and then select 'Phantom mailbox'
Press Speakerphone key when finished
106