Fine Programmed Scan (Vfo Mode) - Icom IC-7100 Instruction Manual

Previous view
12
SCAN OPERATION

Fine programmed scan (VFO mode)

When a signal is received during a Fine programmed
scan, the scanning tuning step is temporarily set to
10 Hz and the scan speed decreases.
q
Start the programmed scan.
• Follow steps q through i as described on page ??-??.
w
While scanning, touch [FINE](
function between a programmed scan and a Fine
programmed scan.
e D) to cancel the scan.
Touch [PROG](
D) to switch the scan
12-9
L eft D isplay R ight
C enter
While Programmed scanning
While Fine programmed scanning
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch panel)
Touch [FINE].
Touch [FINE].