Chapter 6 Cable Connection
6.5 MiniSAS Cable Connection (For SAS)
2
6.5
MiniSAS Cable Connection (For SAS)
Connect the ETERNUS DX60/DX80 and the server with miniSAS cables.
User must prepare their own miniSAS cables (ETERNUS DX60/DX80 connector: SFF8088).
CAUTION
•
Connect the LAN cables to the server or switching hub.
Connect the other end of the LAN cable to the server's LAN card or iSCSI HBA, or to the
switching hub. For switching hub connection details, refer to the documentation for the
switching hub being connected to.
Do
CAUTION
•
Be sure to wear a wrist strap or discharge static electricity by
touching the metal frame of the ETERNUS DX60/DX80 before
starting each operation, as failure to discharge static electricity may
cause device failure.
•
When connecting external (signal, power, etc.) cables, avoid pulling
them as it may cause device damage.
Do Not
•
Do not bend the cable too much or bind it up. Doing so may cause a
device damage or failure.
Do not bend square
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
Do
When connecting the LAN cables, position them so that they
will not obstruct replacement of the power supply unit or
controllers by the maintenance engineer.
90
Do not bind up
116
End of procedure
P3AM-3042-08ENZ0