Installing Ac Outlet Box (1U) - Fujitsu Eternus DX60 User Manual
Disk storage system
Hide thumbs
Also See for Eternus DX60:
- User manual (239 pages) ,
- Operation manual (119 pages) ,
- Product introduction (19 pages)
Table of Contents
Advertisement
Chapter 5 Installation
5.2 Rack Installation
■ 2.5" type drive enclosure
8
5.2.3
Installing AC Outlet Box (1U)
This section describes how to install the 1U AC outlet box in a rack.
•
Use the thumb screw to fasten the front right of the drive enclosure to the rack.
•
After attaching the supplied flange cover, use the thumb screw to fasten the front left of
the drive enclosure to the rack.
For details on how to attach the flange cover, refer to
Flange Cover" (page
78).
Thumb screw
For 3.5" type drive enclosures, finish by replacing the front cover.
For details on how to attach the front cover, refer to
Cover" (page
75).
Do Not
CAUTION
•
AC outlet box cannot be connected to the device other than
ETERNUS DX60/DX80/DX90.
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
(Rear rack pillars)
"3.3 Attaching and Removing the Front
100
"3.4 Attaching and Removing the
End of procedure
P3AM-3042-08ENZ0
Advertisement
Table of Contents
