Fujitsu Eternus DX60 User Manual page 138

Chapter 7 Setup
7.1 Setup Preparation
❏ IP address and subnet mask for the ETERNUS DX60/DX80/DX90's RMT port
No default value is set.
This setting is required if the remote support connection is to be independent of the customer
network.
When enabling the RMT port of a Slave CM for dual controller model, two IP addresses are
required.
❏ Gateway IP address
No default value is set.
❏ IP address for maintenance work
Prepare an IP address for maintenance work.
IMPORTANT
■
Completing and attaching the Network Settings label
Complete the network setting information in the provided Network Settings label and attach it on
the ETERNUS DX60/DX80/DX90.
❏ Completing the Network Settings label
Complete the following items in the Network Settings label.
-
-
-
-
The ETERNUS DX60/DX80/DX90 can be reset to the factory default
network settings by pressing the Controller Enclosure's IP RESET
Switch twice in succession within a two second interval.
IP address of MNT port
IP address of the device MNT port
IP address of FST
IP address for maintenance work
Subnet Mask
Subnet mask of network connected
IP address of RMT port
IP address of the device RMT port
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
138
P3AM-3042-08ENZ0