Figure 7.1 Network Settings Label Attachment - Fujitsu Eternus DX60 User Manual

Chapter 7 Setup
7.1 Setup Preparation
❏ Attaching the Network Settings label
Attach the completed Network Settings label on the label plate in the label holder on the rear
upper side.
Label holder
Figure 7.1
■
Preparation and settings for the PC
The initial settings are performed by using a Web browser running on a LAN connected PC.
Prepare and set up the PC.
❏ Preparing the PC
Prepare the PC with the following settings and requirements.
-
-
Refer
IP address of MNT port
IP address of FST
Subnet Mask
IP address of RMT port
Plate
Tag
Pull out the plate while holding the tag.
Network Settings label attachment
Web browser
Usable Web browsers are as follows. Using Web browsers other than the following is
possible, but proper operation cannot be guaranteed.
• Microsoft® Internet Explorer 6.0, 7.0, 8.0
• Mozilla Firefox 3.0.x, 3.5.x, 3.6.x
Resolution
1024 × 768 or greater
"ETERNUS DX60/DX80/DX90 Web GUI User Guide"
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
Network Settings label
Network Setting
: . .
: . .
: . .
: . .
139
.
.
.
.
P3AM-3042-08ENZ0