Turning The Auto Power Switch On/Off - Fujitsu Eternus DX60 User Manual

Chapter 3 Standard Operations

3.5 Turning the AUTO POWER Switch On/Off

2
■
Procedure for removing the flange cover
Loosen the thumb screw to remove the flange cover.
3.5 Turning the AUTO POWER Switch On/Off
This section explains how to enable the AC automatic linkage mode by turning the AUTO
POWER switch of the controller enclosure to "ON".
When AC automatic linkage mode is enabled, the ETERNUS DX60/DX80/DX90 is automatically
turned on when the power supply recovers after a power failure.
When the AUTO POWER switch of the controller enclosure is set to "OFF", the AC automatic
linkage mode is disabled.
Procedure
1
2
Tighten the thumb screw to fasten the flange cover.
Thumb screw
Remove the front cover from the 3.5" type controller enclosure.
Remove the flange cover from the 2.5" type controller enclosure.
For details on how to remove the front cover, refer to
Front Cover" (page 75).
For details on how to remove the flange cover, refer to
Flange Cover" (page 78).
Turn the AUTO POWER switch of the controller enclosure to "ON".
Push up the AUTO POWER switch to the "ON" side using the pin that is provided with the
ETERNUS DX60/DX80/DX90.
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
"3.3 Attaching and Removing the
"3.4 Attaching and Removing the
79
End of procedure
P3AM-3042-08ENZ0