Fujitsu Eternus DX60 User Manual page 85

Chapter 4 Flow from Installation to Operation
Other Settings
Perform the following settings (as required).
Advanced Copy Setup
(1)
If the Advanced Copy functions are to be used, set them up.
Refer
"7.3 Advanced Copy Setup" (page 164)
Monitoring Setup
(2)
Perform the ETERNUS DX60/DX80/DX90 monitoring setup if required.
•
Notification of ETERNUS DX60/DX80/DX90 problems as they occur is possible if
the event notification method and level have been set.
•
If e-mail notification of ETERNUS DX60/DX80/DX90 errors is to be used, set a
recipient e-mail address.
•
If the "ServerView" server monitoring tool is to be used, perform the settings
required for SNMP Trap Transfers.
•
If the Remote Notice function is to be used, perform the settings required to allow
the ETERNUS DX60/DX80/DX90 to connect to a Fujitsu remote server.
Refer
"7.4 Monitoring Setup" (page 170)
Server Connection Setup
(3)
Perform the settings required to connect to the server. Install the drivers and perform
the network settings.
Refer
"7.5 Server Connection Setup" (page 181)
Operation and Maintenance
Refer
"Chapter 9 Operation and Maintenance" (page 203)
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
85
P3AM-3042-08ENZ0