2.2 2.5" Type Controller Enclosure; Front View; Figure 2.11 Front View Of 2.5" Type Controller Enclosure (With Flange Cover) - Fujitsu Eternus DX60 User Manual

Chapter 2 Components

2.2 2.5" Type Controller Enclosure

2.2 2.5" Type Controller Enclosure
The 2.5" type controller enclosure contains 2.5" disks installed in the front, and controller mod-
ules and power supply units (with fans) in the rear.
2.2.1

Front View

■
With flange cover
Flange cover

Figure 2.11 Front view of 2.5" type controller enclosure (with flange cover)

DISK READY LED
Glows (
are operating normally.
DISK FAULT LED
Glows orange (
Blinks orange (
Disk
Up to 24 disks can be installed in the ETERNUS DX60/DX80/DX90.
POWER LED
Glows green ( ) when the power is
turned on.
READY LED
Glows green ( ) when device is available
for use.
FAULT LED
Glows orange ( ) when an internal device
part abnormality has been detected.
Blinks orange ( ) when a device part which
needs preventive replacement has been
detected.
IDENTIFY LED
Blinks blue ( ) or turns off (
via GUI to identify the enclosure installation
locations.
CACHE LED
Glows green ( ) when there is data in the
device cache.
Blinks ( ) when a power failure has
occurred and the cache data is being saved
to flash memory.
Power switch
Used to turn the device
ON and OFF.
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
) or blinks green ( ) when disks
) when a disk has failed.
) according to the VDS (Microsoft Virtual Disk Service) commands.
) as ordered
57
P3AM-3042-08ENZ0