Fibre Channel Cable Connection (For Fibre Channel) - Fujitsu Eternus DX60 User Manual

Chapter 6 Cable Connection

6.3 Fibre Channel Cable Connection (For Fibre Channel)

3
3-1
3-2
6.3 Fibre Channel Cable Connection (For Fibre Channel)
Connect the ETERNUS DX60/DX80/DX90 and the server or Fibre Channel switch with Fibre
Channel cable.
User must prepare their own Fibre Channel cables.
If the RMT ports are to be used, connect the LAN cables to RMT ports.
Connect the connector of the LAN cable to the RMT port of the controller 0 (CM#0) and
controller 1 (CM#1).
Connect the other end of the LAN cable to the networking equipment, such as hub or
router.
For networking equipment connection details, refer to the documentation for the
networking equipment being connected to.
Do
CAUTION
• Make sure to wear a wrist strap before starting each operation, as
failure to discharge static electricity may cause a device failure.
Do not remove it until the operation is complete.
• When connecting external (signal, power, etc.) cables, avoid pulling
them as it may cause damage.
• Before connecting Fibre Channel cables, confirm that the
connectors are clean and free of dust, oil, and grease, etc.
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
111
End of procedure
P3AM-3042-08ENZ0