Figure 2.6 Eternus Dx60/Dx80 Fibre Channel Model Controller - Fujitsu Eternus DX60 User Manual

Chapter 2 Components
2.1 3.5" Type Controller Enclosure
■
Controller (CM)
●
ETERNUS DX60/DX80 Fibre Channel model
Figure 2.6
Figure 2.6
shows the ETERNUS DX60/DX80 Fibre Channel model controller.
SCU STATUS LED
Glows green ( ) when SCU is normal.
Blinks green ( ) when being charged
(for about one minute after the device power is turned on).
IDENTIFY LED
Blinks blue ( ) or turns off (
identify the enclosure installation locations.
SAS (DE) LINKUP LED
Glows green ( ) when link has been established.
LAN port (1000Base-T/100Base-TX/10Base-T)
(RMT port (left), MNT port (right))
RJ45 connectors for LAN cables
Each controller has two such ports.
ETERNUS DX60/DX80 Fibre Channel model controller
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
) as ordered via GUI to
FC LINKUP/FAULT LED
Glows green ( ) when data is being sent and received.
Glows orange (
in the Fibre Channel port.
Fibre Channel ports 0 (left), 1 (right)
Dual LC connectors for Fibre Channel cables.
UNIT READY/FAULT LED
Glows green (
Glows orange (
initialization phase. Also glows orange (
indicate a fault has been detected.
MASTER LED
Glows green (
as the Master CM.
PWC port
This is not used.
ACT LED
Glows green ( ) when data is being sent and received.
LINK LED
Glows green ( ) when link has been established.
SAS (OUT) port
Connector for a miniSAS cable
Used to connect the Controller Enclosure to a Drive Enclosure.
52
) when a fault has been detected
) during normal operation.
) during the post power on
) when the controller is set
P3AM-3042-08ENZ0
) to