Fujitsu Eternus DX60 User Manual page 190

Chapter 8 Installing Optional Products
8.1 Disk Installation
6-3
6-4
7
8
9
10
11
Swing the lock lever in the direction of the arrow, until the lock clicks shut.
Make sure that the lock lever hooks have engaged the slot
IMPORTANT
protrusions.
Check that the newly installed disk's DISK READY/FAULT LED lights up green after
approximately 30 seconds.
Repeat Step 5 and Step 6
Remove the wrist strap.
Re-attach the front cover.
For details on how to attach the front cover, refer to
Cover" (page 75).
On the Storage System Status screen of GUI, check that the added disks have
been recognized.
Set up RAID groups, volumes, hot spares, and Host Affinity settings on the new
disks, as required.
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
Lock lever
Lock lever hooks Lock lever hooks
have engaged have not engaged
Slot
protrusion
Hook
for each additional disk.
"3.3 Attaching and Removing the Front
190
Slot
protrusion
Hook
End of procedure
P3AM-3042-08ENZ0