Fujitsu Eternus DX60 User Manual page 80

Chapter 3 Standard Operations
3.5 Turning the AUTO POWER Switch On/Off
3
Pin
• The AUTO POWER switch of the drive enclosure is turned to
IMPORTANT
"OFF" as the factory setting, and should not be turned to "ON".
• If AC power is being supplied, turning the AUTO POWER switch
of the controller enclosure to "ON" will cause the ETERNUS
DX60/DX80/DX90 to turn on.
• If the AUTO POWER switch of the controller enclosure is turned
to "ON", connecting the power cord to the outlet will cause the
ETERNUS DX60/DX80/DX90 to turn on.
Re-attach the front cover to the 3.5" type controller enclosure.
Re-attach the flange cover to the 2.5" type controller enclosure.
For details on how to attach the front cover, refer to
Cover" (page 75).
For details on how to attach the flange cover, refer to
Flange Cover" (page 78).
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
AUTO POWER
switch
"3.3 Attaching and Removing the Front
"3.4 Attaching and Removing the
80
End of procedure
P3AM-3042-08ENZ0