Fujitsu Eternus DX60 User Manual page 126

Chapter 6 Cable Connection
6.7 Power Cord Connection
2
Connect the power cords to the power outlet.
Connect the plug at the other end of each power cord to the power outlet.
• Connecting the power cords to different power systems, on the
IMPORTANT
PSU#0 and PSU#1 sides respectively, prevents power supply
facility failures.
• After unplugging the power cord, wait until the POWER STATUS
LED of the power supply unit has turned off completely before
reconnecting it.
(It takes about ten seconds for the STATUS LED to be turned off
completely.)
WARNING
•
CAUTION
•
•
•
•
•
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
Do Not
Do not connect power cords or other cables during
thunderstorms, as lightning can result in fire or electric shock.
Do
Be sure to fully insert each plug into its socket. Failure to do
so may lead to fire or electrical shock.
Do Not
When disconnecting the power plug, be sure to pull from the
plug and not the cord. Pulling the cord may expose or snap
the inner wires, which can lead to fire or electrical shock.
Do not use the server service outlet to connect the device
power cord.
Do not overload an electrical outlet. Doing so may lead to
electric shock or fire.
Unplug
If the ETERNUS DX60/DX80/DX90 is not going to be used for
a long period of time, it is advisable to unplug all power cords
to avoid any chance of fire to the ETERNUS DX60/DX80/
DX90 and its peripherals.
126
End of procedure
P3AM-3042-08ENZ0