Figure 7.23 [Assign Hot Spare] Screen - Fujitsu Eternus DX60 User Manual
Disk storage system
Hide thumbs
Also See for Eternus DX60:
- User manual (239 pages) ,
- Operation manual (119 pages) ,
- Product introduction (19 pages)
Table of Contents
Advertisement
Chapter 7 Setup
7.2 Basic Setup
Procedure
1
2
3
In the GUI screen, click [Assign Hot Spare] under the [RAID Group
Management] menu on the [Volume Settings] tab.
The [Assign Hot Spare] screen appears.
Select the hot spare type and the disk to be used as hot spare, and click the
[Assign] button.
The following is a setting example when "Global Hot Spare" is selected.
When selecting "Dedicated Hot Spare" as the hot spare type, "Select an existing RAID
Group" appears.
Figure 7.23 [Assign Hot Spare] screen
A confirmation screen appears.
Click the [OK] button.
The hot spare is registered.
This ends the basic settings.
If further setup is necessary, refer to the "ETERNUS DX60/DX80/DX90
Web GUI User Guide".
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
163
End of procedure
P3AM-3042-08ENZ0
Advertisement
Table of Contents
