Lan Cable Connection (For Operation Management) - Fujitsu Eternus DX60 User Manual

Chapter 6 Cable Connection

6.2 LAN Cable Connection (for Operation Management)

■
Remote support environment condition checks
If the remote support connection is to be independent of the customer network, the following
components will also be required:
❏ LAN cables × 2 (enhanced Cat-5 twisted-pair type)
❏ Routers and other networking equipment
Refer
■
Related manuals
Prepare the following manuals:
❏ "ETERNUS DX60/DX80/DX90 Web GUI User Guide"
❏ Other related manuals, for example, for a server or networking equipment to be connected to
the ETERNUS DX60/DX80/DX90.
6.2 LAN Cable Connection (for Operation Management)
This ETERNUS DX60/DX80/DX90 must be connected to a LAN to perform settings or mainte-
nance operations via GUI or CLI, to monitor the device status, or when operating with remote
support.
User must prepare their own LAN cables (enhanced Cat-5 twisted-pair type).
IMPORTANT
"ETERNUS DX60/DX80/DX90 Web GUI User Guide"
• The ETERNUS DX60/DX80/DX90 has two LAN ports (1000Base-T/
100Base-TX/10Base-T, MNT port and RMT port) for each controller.
- For device management via GUI or CLI, use MNT port.
For dual controller model, only device monitoring and switching the
Master CM (when an error occurs in the LAN environment) can be
performed from the MNT port of Slave CM.
- For remote support operation, use MNT port or RMT port. For remote
support on a different network to the customer network, use the RMT
port as the remote support port. For remote support over the
customer network, only the MNT port need be used.
- Operation using only the RMT port without the MNT port is not
allowed.
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
108
P3AM-3042-08ENZ0